V-belt Drive Design Process 1. Rated power of the driving motor/prime mover. 2. Service factor based on type of driver and driven load. 3. Center distance (adjustment for center distance must be provided or use idler pulley) 4. Power rating for one belt as a function of size and speed of the smaller pulley 5. Belt length (then choose standard size) 6.
(f) Power Rating The power ratings for 16B chain are given on page 5. The required power rating from step (b) is 1.8 kW. For a 19T driver Selection (a) Service Factor From Table 1, determine the service factor which is applicable to the drive. (b) Design Power Multiply the normal running power by the service factor.
This paper provides to design the conveyor system used for which includes belt speed, belt width, motor selection, belt specification, shaft diameter, pulley, gear box selection, with the help of standard model calculation.
Drive shafts are another common method used to move mechanical power around that is sometimes evaluated in comparison to chain drive; in particular belt drive vs chain drive vs shaft drive is a key design decision for most motorcycles.
Design Project Design and construction of a solar powered vehicle Synopsis In this project you will design and construct a small solar powered vehicle to climb a ramp at the maximum possible speed. 1. Organization This project may be done individually or in groups of up to four students.
Below is an example of a basic portable gantry hoist design. Figure 1: Basic "A" frame gantry hoist (LK Goodwin 2012) This design is relatively easy to assemble while it is lying down but would most likely require two people to stand up. Using two people to stand up the hoist after assembly seems to be an unavoidable factor in the design.